Changeset 601 in xtideuniversalbios for trunk/XTIDE_Universal_BIOS/Src/Device/Serial/SerialDPT.asm

Timestamp:

Feb 14, 2019, 7:38:08 PM (6 years ago)

Author:

Krister Nordvall

Message:

Changes:

• Building the BIOS now works again.
• Added a new IDE device type/transfer mode for use only with XT-IDE rev 2+ (or Chuck(G)-modded rev 1) cards installed in any of the following machines: Olivetti M24, AT&T PC6300, Xerox 6060 and Logabax Persona 1600. This new transfer mode is slightly faster than the regular XT-IDE rev 1 device type and requires that the card is configured for High Speed mode (or, in case of the card being a rev 1 card, has the Chuck(G) mod done). The new device type is called "XTIDE rev 2 (Olivetti M24)" in XTIDECFG.
• Made some minor improvements to the library code that handles 'Drive Not Ready' errors in XTIDECFG.
• Optimizations.

File:

• trunk/XTIDE_Universal_BIOS/Src/Device/Serial/SerialDPT.asm (modified) (2 diffs)

trunk/XTIDE_Universal_BIOS/Src/Device/Serial/SerialDPT.asm

@@ -33 +33 @@
 ;--------------------------------------------------------------------
 SerialDPT_Finalize:
-        mov     ax, [es:si+SerialServer_ATA_wPortAndBaud]
-        mov     [di+DPT_SERIAL.wSerialPortAndBaud], ax
+    mov     ax, [es:si+SerialServer_ATA_wPortAndBaud]
+    mov     [di+DPT_SERIAL.wSerialPortAndBaud], ax
 
 ;
@@ -41 +41 @@
 ; if the floppy support is disabled.
 ;
-        mov     al, [es:si+SerialServer_ATA_wDriveFlags]
-        eSHL_IM al, 1
-        mov     byte [di+DPT.bFlagsHigh], al
-
-        ret
+    mov     al, [es:si+SerialServer_ATA_wDriveFlags]
+    eSHL_IM al, 1
+    mov     BYTE [di+DPT.bFlagsHigh], al
+    ret
 
 %ifndef CHECK_FOR_UNUSED_ENTRYPOINTS